010-151 Free Exam Study Guide! (Updated 138 Questions)
010-151 Dumps for CCT Data Center Certified Exam Questions & Answer
NEW QUESTION 67
Which two statements about PCIe are true? (Choose two.)
- A. A link that is composed of four lanes is called an x4 link.
- B. The PCIe link is built around dedicated unidirectional couples of serial, point-to-point connections known as lanes.
- C. The PCIe standard is a bus-based system in which all the devices share the same bidirectional, 32-bit or 64-bit, parallel signal path.
- D. The PCIe 1.0 standard doubles the transfer rate compared to PCIe 2.0.
- E. You can install a PCI Express x8 adapter into an x4 slot.
Answer: A,B
NEW QUESTION 68
Which command syntax is correct to reset the admin password when the switch is in the kickstart prompt?
switch(boot) #"
- A. connect local-mgmt -> admin-password
- B. configure terminal -> admin-password
- C. admin-password
- D. exec -> admin-password
- E. connect nxos -> admin-password <password>
Answer: B
NEW QUESTION 69
Which tool is needed when servicing a UCS M5 server?
- A. M5 DIMM puller
- B. PCIe slot cover
- C. HDD removal tool
- D. T-30 Torx driver
Answer: D
Explanation:
Explanation/Reference: https://www.cisco.com/c/en/us/td/docs/unified_computing/ucs/c/hw/C220M5/install/C220M5/ C220M5_chapter_010.html
NEW QUESTION 70
Which three steps do you perform to troubleshoot when a rack server powers on with no video? (Choose three.)
- A. Check the front I/O cable connection to the motherboard.
- B. Check for memory subsystem failure.
- C. Verify the power source to equipment.
- D. Reseat the DIMMs, CPU, and PCI cards.
- E. Check that the front I/O dongle is properly seated.
Answer: A,B,E
NEW QUESTION 71
Drag the password recovery procedures on a Cisco NX-OS switch from the left to the right and place them in order.
Answer:
Explanation:
NEW QUESTION 72
Refer to the exhibit.
Which three options are features of the Cisco UCS 6248UP Fabric Interconnect front panel? (Choose three.)
- A. Fan module
- B. Console port
- C. USB port
- D. FCoE port
- E. 10 Gb/s port
Answer: A,B,C
Explanation:
Explanation/Reference:
NEW QUESTION 73
Which Cisco MDS model supports the most Fibre Channel ports per chassis?
- A. MDS 9506
- B. MDS 9250i
- C. MDS 9509
- D. MDS 9513
Answer: D
NEW QUESTION 74
Which two virtualization technologies are used in a modern data center design? (Choose two.)
- A. Cloud virtualization
- B. Platform virtualization
- C. Application virtualization
- D. Server virtualization
- E. Storage virtualization
Answer: B,D
NEW QUESTION 75
Which two blade servers support GPUs? (Choose two.)
- A. UCS B420 M4
- B. UCS B480 M5
- C. UCS B260 M4
- D. UCS B200 M4
- E. UCS B200 M5
Answer: B,E
NEW QUESTION 76
What is the correct path to verify the Overall Status of Chassis 1 | Server 3?
- A. Status Tab > Chassis > Chassis 1 > Servers > Server 3
- B. Servers Tab > Chassis > Server 3 General tab
- C. Equipment Tab > Chassis > Chassis 1 > Servers > Server 3 FSM tab
- D. Admin Tab > Chassis > Chassis 1 > Servers > Server 3 General tab
- E. Equipment Tab > Chassis > Chassis 1 > Servers > Server 3 General tab
- F. Equipment Tab > Chassis > Chassis 1 > Servers > Server 3 Status tab
Answer: E
NEW QUESTION 77
Refer to the exhibit.
Which three options are features of the Cisco UCS 6248UP Fabric Interconnect front panel? (Choose three.)
- A. Fan module
- B. Console port
- C. USB port
- D. FCoE port
- E. 10 Gb/s port
Answer: A,B,C
NEW QUESTION 78
Refer to the exhibit.
This image shows a CPU Pick-and-Place tool and a CPU Socket Protective Cap Removal tool.
Which types of Cisco UCS servers and Intel Xeon processors do these tools support?
- A. Cisco UCS B200 M3 Blade Server, B420 M3 Blade Server, C220 Rack Server, C240 Rack Sever, and C420 Rack Sever with Intel Xeon E5-2600 Series processors
- B. Cisco UCS B200 M3 Blade Server, B420 M3 Blade Server, C220 Rack Server, C240 Rack Sever, and C420 Rack Sever with Intel Xeon E5-2400 Series processors
- C. Cisco UCS B22 Blade Server, C22 Rack Server, and C24 Rack Sever with Intel Xeon E5- 2600 Series processors
- D. Cisco UCS B22 Blade Server, C22 Rack Server, and C24 Rack Sever with Intel Xeon E5- 2400 Series processors
Answer: A
NEW QUESTION 79
Which three statements about powering down a Cisco UCS C-Series Rack-Mount Server to perform maintenance or replacement are true? (Choose three.)
- A. Power status LED. Green indicates that the server is in main power mode and can be safely powered off.
- B. Standby power mode: Power is supplied only to the service processor and the cooling fans, and it is safe to power off the server from this mode.
- C. The Cisco UCS C-Series Rack-Mount Server has only one power mode.
- D. Graceful shutdown: Press and release the power button. The operating system performs a graceful shutdown, and the server goes to standby mode, which is indicated by an amber power status LED.
- E. Disconnect the power cords from the power supplies in your server to completely power off the server.
- F. Only an emergency shutdown can be performed using the power button on the server front panel.
Answer: B,D,E
NEW QUESTION 80
When the Cisco UCS Manager is used to verify the B- or C-Series device, which two types of Overall Status are acceptable and do not indicate a failure? (Choose two.)
- A. OK
- B. Unassociated
- C. Active
- D. Online
Answer: A,B
NEW QUESTION 81
What is the maximum number of supervisor modules that the Cisco MDS 9710 Switch supports?
- A. 0
- B. 1
- C. 2
- D. 3
- E. 4
Answer: E
NEW QUESTION 82
Which two types of information does the show module NX-OS command display? (Choose two.)
- A. Module IP address
- B. Module type
- C. Module status
- D. Module ports type
- E. Module license information
Answer: B,C
Explanation:
Explanation/Reference: https://www.cisco.com/en/US/docs/switches/datacenter/sw/4_2/nx-os/system_management/ command/reference/sm_cmd_show.html
NEW QUESTION 83
Which transceiver can support 400 Gigabit Ethernet?
- A. QSFP-DD
- B. QSFP28
- C. SFP-DD
- D. QSFP+
Answer: A
Explanation:
Explanation/Reference: https://www.cisco.com/c/en/us/products/collateral/interfaces-modules/transceiver-modules/ datasheet-c78-743172.html
NEW QUESTION 84
Refer to the exhibit.
Which statement correctly identifies the front panel LEDs on the Cisco UCS C220 Server?
- A. A is network link activity LED; B is system status LED; C is identification button and LED; D is power button and power status LED.
- B. A is system status LED; B is network link activity LED; C is power button and power status LED; D is identification button and LED.
- C. A is network link activity LED; B is system status LED; C is power button and power status LED; D is identification button and LED.
- D. A is power button and power status LED; B is identification button and LED; C is system status LED; D is network link activity LED.
Answer: D
NEW QUESTION 85
Refer to the exhibit.
What is the name of this rack-mount server?
- A. Cisco UCS C460 Rack-Mount Server
- B. Cisco UCS C420 Rack-Mount Server
- C. Cisco UCS C240 Rack-Mount Server
- D. Cisco UCS C220 Rack-Mount Server
Answer: B
NEW QUESTION 86
When the Cisco UCS Manager is used to verify the B- or C-Series device, which two types of Overall Status are acceptable and do not indicate a failure? (Choose two.)
- A. OK
- B. Unassociated
- C. Active
- D. Online
Answer: A,B
NEW QUESTION 87
What is the correct path to verify the Overall Status of Chassis 1 | Server 3?
- A. Status Tab > Chassis > Chassis 1 > Servers > Server 3
- B. Servers Tab > Chassis > Server 3 General tab
- C. Equipment Tab > Chassis > Chassis 1 > Servers > Server 3 FSM tab
- D. Admin Tab > Chassis > Chassis 1 > Servers > Server 3 General tab
- E. Equipment Tab > Chassis > Chassis 1 > Servers > Server 3 General tab
- F. Equipment Tab > Chassis > Chassis 1 > Servers > Server 3 Status tab
Answer: E
NEW QUESTION 88
Which Cisco MDS 9700 Series platform supports the Supervisor-1E module?
- A. Cisco MDS 9709
- B. Cisco MDS 9706
- C. Cisco MDS 9718
- D. Cisco MDS 9710
Answer: C
NEW QUESTION 89
What does the system status LED look like when an over temperature or major alarm occurs on the Cisco UCS 6120XP Fabric Interconnect?
- A. Blinking amber
- B. Amber
- C. Blinking red
- D. Red
Answer: A
NEW QUESTION 90
Which method does FCIP use to enable connectivity of geographically distributed Fibre Channel SANs over IP?
- A. handshaking
- B. transporting
- C. tunneling
- D. routing
Answer: C
NEW QUESTION 91
Which supervisor module is supported by a Cisco Nexus 7700 Series Switch?
- A. second-generation supervisor enhanced module (Sup2E)
- B. first-generation supervisor module
- C. second-generation supervisor module (Sup2)
- D. third-generation supervisor enhanced module (Sup3E)
Answer: A
NEW QUESTION 92
......
Use Real 010-151 Dumps - 100% Free 010-151 Exam Dumps: https://freecert.test4sure.com/010-151-exam-materials.html