2024 Updated 300-430 Tests Engine pdf - All Free Dumps Guaranteed!
Latest CCNP Enterprise 300-430 Actual Free Exam Questions
NEW QUESTION # 29
An engineer has configured Media Stream on the WLC and must guarantee at least 2 Mbps stream per user. Which RRC template should the engineer use?
- A. medium
- B. ordinary
- C. coarse
- D. low
Answer: A
Explanation:
NEW QUESTION # 30
Which devices can be tracked with the Cisco Context Aware Services?
- A. Cisco certified wireless devices
- B. wired and wireless devices
- C. wired devices
- D. wireless devices
Answer: B
Explanation:
Explanation/Reference: https://www.cisco.com/c/en/us/support/docs/wireless/context-aware-software/110836-cas-faq.html
NEW QUESTION # 31
A corporation has employees working from their homes. A wireless engineer must connect 1810 OEAP at remote teleworker locations. All configuration has been completed on the controller side, but the network readiness is pending. Which two configurations must be performed on the firewall to allow the AP to join the controller? (Choose two.)
- A. Allow UDP ports 12222 and 12223 on the firewall.
- B. Configure a static IP on the OEAP 1810.
- C. Block UDP ports 1812 and 1813 on the firewall.
- D. Allow UDP ports 5246 and UDP port 5247 on the firewall.
- E. Enable NAT Address on the 5520 with an Internet-routable IP address.
Answer: A,D
Explanation:
Explanation
Graphical user interface, text, application Description automatically generated
NEW QUESTION # 32
A customer reports that wireless clients are not able to receive multicast data from known working multicast servers on the wired network. The client is connecting at the highest mandatory wireless rate of 24 Mbps and the wireless controller is configured for multicast-unicast mode. What three actions should the engineer take next to troubleshoot the issue? (Choose three.)
- A. verify that the L3 interfaces are configured for pim sparse-dense-mode on the VLAN servicing the wireless access points as well as the wireless controller's management VLAN
- B. verify that Global Multicast mode has been enabled
- C. verify that IGMP snooping is disabled on the wireless controller since the access points are handling IGMP messages from the clients
- D. verify Multicast Listener Discovery (MLD) v1 snooping has been enabled to keep track of and deliver IPv4 multicast flows
- E. change the wireless controller from Multicast-Unicast mode to Multicast-Multicast mode and assign a multicast address in the 239.X.X.X/8 subnet
- F. make sure the highest mandatory rate is set to 54 Mbps so that the multicast traffic has sufficient bandwidth
Answer: A,B,E
NEW QUESTION # 33
A network engineer is deploying 8865 IP phones with wireless clients connected to them. In order to apply the appropriate QoS, the IP voice traffic needs to be distinguished from client data traffic. Which switch configuration feature must be enabled?
- A. Voice VLAN
- B. WME
- C. QoS routing
- D. QBSS
Answer: A
NEW QUESTION # 34
What must be configured on ISE version 2.1 BYOD when using Single SSID?
- A. 802.1x
- B. open authentication
- C. no authentication
- D. WPA2
Answer: D
Explanation:
NEW QUESTION # 35
An engineer must implement rogue containment for an SSID. What is the maximum number of APs that should be used for containment?
- A. 0
- B. 1
- C. 2
- D. 3
Answer: C
Explanation:
NEW QUESTION # 36
A network engineer observes a spike in controller CPU overhead and overall network utilization after multicast is enabled on a controller with 500 APs. Which feature connects the issue?
- A. broadcast forwarding
- B. controller IGMP snooping
- C. multicast AP multicast mode
- D. unicast AP multicast mode
Answer: C
NEW QUESTION # 37
Refer to the exhibit.
A wireless engineer has integrated the wireless network with a RADIUS server. Although the configuration on the RADIUS is correct, users are reporting that they are unable to connect. During troubleshooting, the engineer notices that the authentication requests are being dropped. Which action will resolve the issue?
- A. Provide a valid client username that has been configured on the RADIUS server.
- B. Authenticate the client using the same EAP type that has been set up on the RADIUS server.
- C. Configure the shared-secret keys on the controller and the RADIUS server.
- D. Allow connectivity from the wireless controller to the IP of the RADIUS server.
Answer: C
NEW QUESTION # 38
Which component must be integrated with Cisco DNA Center to display the location of a client that is experiencing connectivity issues?
- A. Cisco Mobility Services Engine
- B. Cisco Hyperlocation Module
- C. Wireless Intrusion Prevention System
- D. Cisco Connected Mobile Experiences
Answer: D
NEW QUESTION # 39
What is an important consideration when implementing a dual SSID design for BYOD?
- A. If multiple WLCs are used, the WLAN IDs must be exact for the clients to be provisioned and traverse the network correctly.
- B. SSIDs for this setup must be configured with NAC State-RADIUS NAC for the clients to authenticate with Cisco ISE, or with NAC State-ISE NAC for Cisco ISE to associate the client.
- C. One SSID is for provisioning and the other SSID is for gaining access to the network. The use of an ACL should not be enforced to make the client connect to the REAL SSID after provisioning.
- D. After using the provisioning SSID, an ACL that used to make the client switch SSIDs forces the user to associate and traverse the network by MAC filtering.
Answer: C
Explanation:
NEW QUESTION # 40
Refer to the exhibit.
An engineer is creating an ACL to restrict some traffic to the WLC CPU. Which selection must be made from the direction drop-down list?
- A. To have the complete list of options, the CPU ACL must be created only by the CLI.
- B. Packet direction has no significance; it is always Any.
- C. It must be Outbound because it is traffic that is generated from the WLC.
- D. It must be Inbound because traffic goes to the WLC.
Answer: D
Explanation:
NEW QUESTION # 41
Where is Cisco Hyperlocation enabled on a Cisco Catalyst 9800 Series Wireless Controller web interface?
- A. Flex Profile
- B. Policy Profile
- C. AP Join Profile
- D. RF Profile
Answer: C
Explanation:
Explanation/Reference: https://www.cisco.com/c/en/us/td/docs/wireless/controller/9800/config-guide/b_wl_16_10_cg/cisco- hyperlocation.html
NEW QUESTION # 42
What is configured to use more than one port on the OEAP to extend the wired network's?
- A. AAA override
- B. remote LAN ACL
- C. client load balancing
- D. remote LAN
Answer: D
NEW QUESTION # 43
A WLC must be configured to allow multiple mDNS profiles based on a user authentication profile configured in Cisco ISE. Which WLAN setting must be configured?
- A. AAA Override
- B. mDNS Snooping
- C. mDNS policy
- D. service advertisement
Answer: A
NEW QUESTION # 44
An engineer configures a Cisco Aironet 600 Series OfficeExtend AP for a user who works remotely. What is configured on the Cisco WLC to allow the user to print a printer on his home network?
- A. AP failover priority
- B. FlexConnect
- C. split tunneling
- D. SE-connect
Answer: C
Explanation:
Explanation/Reference: https://www.cisco.com/c/en/us/support/docs/wireless/aironet-602-officeextend-access- point/117540-configure-splittunneloeap-00.html
NEW QUESTION # 45
An engineer is implementing a FlexConnect group for access points at a remote location using local switching but central DHCP. Which client feature becomes available only if this configuration is changed?
- A. fast roaming
- B. multicast
- C. static IP
- D. mDNS
Answer: C
Explanation:
Explanation
https://www.cisco.com/c/en/us/td/docs/wireless/controller/8-7/config-guide/b_cg87/flexconnect.html
NEW QUESTION # 46
Which QoS level is recommended for guest services?
- A. gold
- B. platinum
- C. silver
- D. bronze
Answer: D
Explanation:
NEW QUESTION # 47
......
300-430 Dumps Updated Practice Test and 281 unique questions: https://freecert.test4sure.com/300-430-exam-materials.html