[Sep 26, 2025] 200-301 Practice Exam Dumps - 99% Marks In Cisco Exam
Updated Verified 200-301 Q&As - Pass Guarantee or Full Refund
Cisco 200-301 certification exam is a single exam that replaces the previous CCNA exams. The new exam includes updated content and technologies to reflect the evolving landscape of networking. 200-301 exam has a duration of 120 minutes, and consists of 100-120 questions. 200-301 exam can be taken at any Pearson VUE testing center, and candidates can schedule their exam online.
NEW QUESTION # 186
Which action is taken by a switch port enabled for PoE power classification override?
- A. When a powered device begins drawing power from a PoE switch port a syslog message is generated
- B. If a monitored port exceeds the maximum administrative value for power, the port is shutdown and err-disabled
- C. If a switch determines that a device is using less than the minimum configured power it assumes the device has failed and disconnects
- D. As power usage on a PoE switch port is checked data flow to the connected device is temporarily paused
Answer: B
NEW QUESTION # 187
Refer to the exhibit.
What action establishes the OSPF neighbor relationship without forming an adjacency?
- A. modify process ID
- B. modify priority
- C. modify hello interval
- D. modify network type
Answer: C
NEW QUESTION # 188
Refer to the exhibit.
An engineer is configuring the HO router. Which IPv6 address configuration must be applied to the router fa0'1 interface for the router to assign a unique 64-brt IPv6 address to Itself?
- A. ipv6 address 2001:DB8:0:1:C601:42FF:FE0F:7/64
- B. ipv6 address 2001 :DB8:0:1:FFFF:C601:420F:7/64
- C. ipv6 address 2001:DB8:0:1:C601:42FE:800F:7/64
- D. iov6 address 2001 :DB8:0:1:FE80:C601:420F:7/64
Answer: C
NEW QUESTION # 189
After you deploy a new WLAN controller on your network, which two additional tasks should you consider? (Choose two)
- A. configure additional security policies
- B. deploy POE switches
- C. deploy load balancers
- D. configure multiple VRRP groups
- E. configure additional vlans
Answer: A,C
Explanation:
In order of importance security policies and load balancing should be at the top of the list. POE would likely be third in line mainly because this would be a budgeted consideration and not necessarily an immediate post-deployment task requirement.
NEW QUESTION # 190
When the active router in an HSRP group fails, what router assumes the role and forwards packets?
- A. backup
- B. standby
- C. forwarding
- D. listening
Answer: B
NEW QUESTION # 191
Refer to the exhibit.
The default-information originate command is configured under the R1 OSPF configuration After testing workstations on VLAN 20 at Site B cannot reach a DNS server on the Internet Which action corrects the configuration issue?
- A. Configure the ip route 0.0.0.0 0.0.0.0 10.10.10.18 command on R1
- B. Add the default-information originate command onR2
- C. Add the always keyword to the default-information originate command on R1
- D. Configure the ip route 0.0.0.0 0.0.0.0 10.10.10.2 command on R2
Answer: A
NEW QUESTION # 192
A network engineer is configuring an OSPFv2 neighbor adjacency Drag and drop the parameters from the left onto their required categories on the right. Not all parameters are used
Answer:
Explanation:
NEW QUESTION # 193
Which two capabilities of Cisco DNA Center make it more extensible? (Choose two.)
- A. modular design that is upgradable as needed
- B. REST APIs that allow for external applications to interact natively with Cisco DNA Center
- C. customized versions for small, medium, and large enterprises
- D. adapters that support all families of Cisco IOS software
- E. SDKs that support interaction with third-party network equipment
Answer: B,E
Explanation:
Section: Automation and Programmability
NEW QUESTION # 194
Refer to the exhibit.
How many objects, Keys and JSON list values are present?
- A. three objects, three keys and two JSON Ml values
- B. one object, three keys, and three JSON list values
- C. one object, three keys and two JSON list values
- D. three objects, two Keys, and three JSON list values
Answer: B
NEW QUESTION # 195
An engineer is configuring NAT to translate the source subnet of 10.10.0.0/24 to any of three addresses
192.168.30.1, 192.168.3.2, 192.168.3.3 Which configuration should be used?
- A. Option A
- B. Option B
- C. Option D
- D. Option C
Answer: D
NEW QUESTION # 196
Refer to the exhibit. When PC 1 sends a packet to PC2,the packet has. Which source and destination IP address when it arrives at interface Gi0/0 on router R2?
- A. source 192.168.10.10 and destination 192.168.20.10
- B. source 192.168.20.10 and destination 192.168.20.1
- C. source 10.10.1.1 and destination 10.10.2.2
- D. source 192.168.10.10 and destination 10.10.2.2
Answer: A
Explanation:
The source and destination IP addresses of the packets are unchanged on all the way. Only source and destination MAC addresses are changed.
NEW QUESTION # 197
Refer to the exhibit.
The New York router is configured with static routes pointing to the Atlanta and Washington sites. Which two tasks must be performed so that the Serial0/0/0 interfaces on the Atlanta and Washington routers can reach one another?
(Choose two.)
- A. Configure the ipv6 route 2012::/126 2023::2 command on the Washington router.
- B. Configure the ipv6 route 2023::/126 2012::1 command on the Atlanta router.
- C. Configure the ipv6 route 2023::/126 2012::2 command on the Atlanta router.
- D. Configure the Ipv6 route 2012::/126 s0/0/0 command on the Atlanta router.
- E. Configure the ipv6 route 2012::/126 2023::1 command on the Washington router.
Answer: A,C
Explanation:
The short syntax of static IPv6 route is:ipv6 route <destination-IPv6-address> {next-hop-IPv6-address | exit- interface}
NEW QUESTION # 198
Refer to Exhibit. Which action do the switches take on the trunk link?
- A. The trunk does not form, but VLAN 99 and VLAN 999 are allowed to traverse the link.
- B. The trunk forms but VLAN 99 and VLAN 999 are in a shutdown state.
- C. The trunk forms but the mismatched native VLANs are merged into a single broadcast domain.
- D. The trunk does not form and the ports go into an err-disabled status.
Answer: C
Explanation:
The trunk still forms with mismatched native VLANs and the traffic can actually flow between mismatched switches. But it is absolutely necessary that the native VLANs on both ends of a trunk link match; otherwise a native VLAN mismatch occurs, causing the two VLANs to effectively merge. For example with the above configuration, SW1 would send untagged frames for VLAN 999. SW2 receives them but would think they are for VLAN 99 so we can say these two VLANs are merged.
NEW QUESTION # 199
Drag and drop the statements about networking from the left onto the corresponding networking types on the right. Not all statements are used.
Answer:
Explanation:
NEW QUESTION # 200
Drag and drop the DNS lookup components from the left onto the functions on the right.
Answer:
Explanation:
Explanation:
NEW QUESTION # 201
What is the benefit of using FHRP (First Hop Redundancy Protocol)?
- A. Reduced management overhead on network routers
- B. Higher degree of availability
- C. Balancing traffic across multiple gateways in proportion to their loads
- D. Reduced ARP traffic on the network
Answer: B
NEW QUESTION # 202
Under which circumstance is a router on a stick most appropriate?
- A. When a router have single subnet on multiple physical links.
- B. When a router have multiple interface on single physical links.
- C. When a router have single interface on multiple physical links.
- D. When a router have multiple subnets on a single physical link.
Answer: D
NEW QUESTION # 203
Refer to the exhibit.
Which switch becomes the root of a spanning tree for VLAN 20 if all li links are of equal speed?
- A. SW2
- B. SW4
- C. SW1
- D. SW3
Answer: A
NEW QUESTION # 204
Refer to the exhibit.
A network engineer must configured communication between PC A and the File Server. To prevent interruption for any other communications, which command must be configured?
- A. Switchport trunk allowed vlan none
- B. Switchport trunk allowed vlan remove 10-11
- C. Switch trunk allowed vlan 12
- D. Switchport trunk allowed vlan add 13
Answer: A
NEW QUESTION # 205
Drag and drop the characteristics of network architectures from the left onto the type of architecture on the right.
Answer:
Explanation:
NEW QUESTION # 206
Refer to the exhibit. When PC 1 sends a packet to PC2,the packet has.
Which source and destination IP address when it arrives at interface Gi0/0 on router R2?
- A. source 192.168.10.10 and destination 192.168.20.10
- B. source 192.168.20.10 and destination 192.168.20.1
- C. source 10.10.1.1 and destination 10.10.2.2
- D. source 192.168.10.10 and destination 10.10.2.2
Answer: A
Explanation:
The source and destination IP addresses of the packets are unchanged on all the way. Only source and destination MAC addresses are changed.
NEW QUESTION # 207
Refer to the Exhibit.
Refer to the exhibit. An engineer is asked to confee router R1 so that it forms an OSPF single-area neighbor relationship with R2. Which command sequence must be implemented to configure the router?
- A. Option A
- B. Option B
- C. Option D
- D. Option C
Answer: B
NEW QUESTION # 208
......
200-301 Real Valid Brain Dumps With 1195 Questions: https://freecert.test4sure.com/200-301-exam-materials.html